8
V1.0
DMX Protocol
1 Channel Mode
Function
Function Control
CH1
Dimmer
000-255: 0-100% dimmer
2 Channels Mode
Function
Function Control
CH1
Dimmer
000-255: 0-100% dimmer
CH2
Strobe
000-255: Strobe with speed increasing
3 Channels Mode
Function
Function Control
CH1
Dimmer
000-255: 0-100% dimmer
CH2
Dimmer fine
000-255: 16 bit dimmer
CH3
Strobe
000-255: Strobe with speed increasing
Fixture Cleaning
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses and mirror should be carried
out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture
operates (I.e. smoke, fog residue, dust, dew). In heavy club use we recommend cleaning on a monthly basis. Periodic
cleaning will ensure longevity, and crisp light output.
To clean the fixture:
1.
Disconnect the fixture from power and allow it to cool for at least 10 minutes.
2.
Vacuum or gently blow away dust and loose particles from the outside of the fixture with low-pressure
compressed air.
3.
Clean the surfaces by wiping gently with a soft, clean lint-free cloth moistened with a weak detergent solution.
Do not rub glass surfaces hard: lift particles off with soft repeated pressure. Dry with a soft, clean, lint-free
cloth or low-pressure compressed air. Remove stuck particles with an unscented tissue or cotton swab
moistened with glass cleaner or distilled water.
4.
Check that the fixture is dry before connecting to power.
Fuse Replacement
This fuse is located in a fuse holder next to the MAINS OUT socket on the connections panel. To
replace a fuse:
1.
Disconnect the fixture from power and allow it to cool for at least 10 minutes.
2.
Unscrew the cap of the fuse holder and remove the fuse. Replace with a fuse of the same size and rating
only.
3.
Reinstall the fuse holder cap before connecting to power.
Troubleshooting
Listed below are a few common problems that you may encounter, with solutions.
The fixture does not work, no light
•
Check the connection of power and main fuse. Be sure the external fuse has not blown.
•
Measure the mains voltage on the main connector.