ACBU011/ACLU011 User Manual
Page 1
7
of 23
Minimum Power/Ampere
– Set the minimum Power or Current (depend from the flag in
Watt/Ampere field (see fig. 4.5)) for each BUC or LNB and must be lower than minimum
power (current) value for BUC or LNB, but can’t be lower than 0.02 A.
Maximum Power/Ampere
– Set the maximum Power or Current for each BUC and LNB
and must be higher than maximum power (current) value for BUC or LNB, but can’t be higher
than 5 A.
WS Motor Voltage
– Set the nominal voltage value that written in specifications for your
switch device.
REF Mode
— Chose between Autodetect and External reference frequency.
Watt/Ampere
— Chose what parameter will be shown in the Minimum/Maximum Power cells.
Redundancy (in development)
— Chose operation mode for your Redundancy System.
Power can be supplied for both BUCs (
Hot
) or only for the active one (
Cold
).
Power Supply Priority
— Set priority of device power supply. Power Supply
Priority
function is searching available power supply and use it in the case that supply parameters
are in setting limits. If supply parameters are correct, device feeds in accordance to the
established priority:
“0” – the highest priority
“2” – the lowest priority
Serial Interface
— Set parameters of Redundancy connection with BUC via M&C interface.
Choose port you want to enable and set it parity, speed and bit rare (Bit rate speed depends
on BUC’s version).
Alarm Enable
— Enable or disable summary BUC alarm via M&C cable.
Power Enable
— Enable or disable power supply alarm for BUC or LNB.
File Name
— Set the name of the file to save configuration parameters. By default, file’s
name
bucparameters.dat
.
Send to file
— Setted configuration will be saved only in created configuration file (by default
bucparameters.dat
).
Read from File
— All parameters are included in the special file you create. This option is
useful when you have many configuration profiles so you can switch profiles without lost any
of them. Created file will contain in a program folder. By default, file’s name
bucparameters.dat
.
Read from Device
— All parameters are loaded in your Redundancy device.
Send to device
— Setted configuration will be uploaded in your device.
ESC
— Push button to return to the Redundancy Status Window.
