Red = Charging
Charging the skateboard is indicated by the LED indicator on the charger. The LED
will turn from red to green as it fi nishes char
IV. CARE &MAINTENANCE
Other maintenance
6
V. TROUBLESHOOTING
being
Symptom
Probable Cause
Remote lose re-sync
Solution
Won’t turn on
Low Battery
Won’t go
Bluetooth not connected
Won’t charge
Charger not connected
Battery depleted
Range too low
Exceed the weight limit
Battery health dropped
Clean the surface of ACTON BLINK® S2 with a damp, but not overly wet, soft cloth
only. Store ACTON BLINK® S2 in an indoor and cool environment. Recharge the
battery at least once per month and avoid contacting with volatile liquids including
Alcohol or strong cleaning agents.
If your ACTON BLINK® S2 is not running properly, stop using it immediately. In most
cases, turning the skateboard off for 10 seconds and restarting it will solve the issue. If
you find other problems or restarting the ACTON BLINK® S2 doesn’t resolve the issue,
refer to the following chart for common troubleshooting methods. If the problem still
exists, please stop using the ACTON BLINK® S2 and contact ACTON.
Charge battery for at least 1 hour
Restart the remote and BLINK S2
Make sure you are using the correct
charger and it is properly connected
If battery has not been charged for
MORE than one month, it may REQUIRE
an extra hour before it will recharge
ACTON BLINK S2 is designed for a
person who weighs up to 250lbs
May need to replace the battery pack
A fast blinking light on the remote is an indication if the remote is in low battery.
Please refer to resync manual to
resync the remote