15
10.
Line up the water connections on the back of the power pack with
the fittings on the side of the spa.
11.
Attach the bottom, large fitting on the back of
the power pack to the corresponding fitting on
the spa, being careful not to cross-thread the
fitting. Make sure the o-ring inside the fitting
is properly seated and labels are completely
removed. Hand tighten the connection nut.
Next, attach the middle and upper hose
connections from the power pack to the spa.
Make sure the hose washers are in place and
seated inside the connections. Tighten the
fittings hand-tight.
12.
With the power
pack unplugged,
remove the key lock
pin and inflation
hose from the top
of power pack.
Loosen the set
screws on the side
of the air loop
fittings. Insert the air loop onto the blower connections on the top
of the power pack until snug. Tighten the set screws.
13.
Finally, place the inflated connection collar between power pack
and spa.
