5
Your Atomic (Radio Controlled) Talking Alarm Clock uses buttons to set the Alarm
Time (Hour and Minute) instead of using a needle as the indicator. This helps visually
impaired people to set the alarm time easily using the talking function and improves the
setting accuracy.
Set Daily Alarm (S2 / S3)
1.
Press S2 twice. The clock says the current Alarm Hour.
2.
Press S2 repeatedly, one press after another, to set a new Alarm Hour. Listen very
carefully to the clock to make sure the right AM or PM has been set.
3.
Press S3 repeatedly, one press after another, to set a new Alarm Minute.
4.
Press S1 to confirm the new Alarm Time setting (or the clock will confirm by itself
one minute later) and the clock will speak the new Alarm time that you have set after
the confirmation.
Set Daily Alarm On or Off (S2 / S3)
1.
Press and Hold S3 for more than 3 seconds to set the alarm status to ON or OFF.
While holding the button down, the clock tells you the current alarm ON/OFF setting
by saying “Alarm On” or “Alarm Off”.
2.
After hearing the alarm ON/OFF setting, release the S3 button and then press the left
button (S2) to listen to the alarm time and make sure the alarm ON/OFF is set
according to your request.
3.
When Alarm is set to OFF, the alarm will not beep, regardless of your alarm time
setting.
Snooze Alarm (S1)
1.
Press S1 once when the Alarm is “Beeping” to set the clock to Snooze mode.
2.
The clock will “Beep” again 5 minutes later.
3.
You can set the clock to Snooze mode a total of 5 times in a row.
Stop Alarm Sound (S1 / S4)
1.
Press and Hold S1 until the clock talks the current time to completely stop the alarm
sound (without using Snooze.)
2.
The Alarm is a Daily alarm, so the alarm will beep again 24 hours later at the same
set alarm time.
3.
To turn OFF Daily alarm go to previous section “Set Daily Alarm On or Off”
4.
Another way to turn off the Daily Alarm sound is to slide the Volume Control (S4) to
the “Off” position. (Note: This will turn off sound completely for all other Talking
Functions. Remember to turn the Volume back on if you want to resume using the
Talking Functions.)
