4
2.
Press S7 once to hear the current USA Time Zone Setting. (The clock is preset at the
factory to Pacific Time Zone.)
3.
Push S7 repeatedly to advance through the USA Time Zones until you hear the
correct zone for your area:
USA, Pacific
USA, Mountain
USA, Central
USA, Eastern
3. Press S1 to confirm the setting after the new Time Zone is set (or the clock will
confirm by itself automatically one minute later.) The clock automatically advances to
the new time zone setting after confirmation. Please wait while the second hand is
running fast. The clock functions will resume working when the correct time has been
reached.
DST ON/OFF setting (S8)
1.
Open the battery cover to reach the DST button (S8).
2.
The Daylight Savings Time (DST) button is preset at factory to ON.
3.
Press down on this button to set DST to OFF if you live in a State where there is no
change to DST. Otherwise, always leave this button set to ON year-round and your
clock automatically adjusts to DST.
WAVE Button - Manual Signal reception (S5)
Pushing the Wave button causes the clock to search for time signal immediately instead
of waiting for automatic signal search, which occurs every night. Place the clock on a
wooden table near a window when you want to allow the clock to manually search for
signal reception.
While the clock is in the running normally:
1.
Press S5 (Wave Button on back of clock) once to initiate manual signal reception.
(The second hand stops at 12 o’clock position during signal reception. The minute
hand advances one minute every 60 seconds and continues to keep time.)
2.
The clock takes about 5 to 14 minutes to pick up the radio signal. Wait until the
clock has finished the signal reception procedure and sets the correct time.
3.
After signal reception, the clock will show the correct time after the fast running
second-hand has stopped.
4.
Push S1 3 times in a row after the clock resumes running to check if reception was
successful or failed.
•
If reception was successful, the clock says, “Country Name” follow by “Time
Updated”
•
If reception failed, the clock says, ”Country Name” follow by “Time Not
Updated”
(Go to Reception Status Check section for details)
Alarm Setting Functions: (S2 / S3)
