33
Mid-size Scooter Series
WARNING! Ensure that the axle key is properly installed into the axle slot when mounting
the wheel. If not installed securely, the braking system is disengaged which may cause
personal injury and/or product damage may result.
10. Reinstall the drive wheel nuts and washers onto the axle and tighten.
WARNING! Make sure that both the nuts and washers are reinstalled and tightened
properly.
11. Inflate tires to the pressure in psi/bar/kPa indicated in each tire.
12. Remove the blocks from beneath the scooter.
EXTERIOR SURFACES
Bumpers, tires and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl seat or tire
tread, as this may cause them to become dangerously slippery.
CLEANING AND DISINFECTION
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter.
Avoid using products that may scratch the surface of your scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or
cleaning agent before applying it to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/or scooter finishes.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and uncorroded.
The batteries must sit flat in the battery wells.
The battery terminals should face towards the outside of the scooter.
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power cord, for wear or damage.
Have your authorized Provider repair or replace any damaged connector, connection, or insulation that
you find before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements
for ingress of liquids, you should keep electrical connections away from sources of
dampness, including direct exposure to water or bodily fluids and incontinence. Check
electrical components frequently for signs of corrosion and replace as necessary.
WARNING! Do not pull on electrical harnesses directly to detach them from the scooter.
Always grasp the connector itself when disconnecting the harness to prevent wire
damage.
ABS PLASTIC SHROUDS
The front tiller shroud, front shroud and the rear shroud are formed from durable plastic and are coated
with an advanced formula urethane paint.
A light application of car wax will help the shrouds retain their high gloss.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all prelubricated, sealed and require no subsequent lubrication.
V I I I . C A R E A N D M A I N T E N A N C E
