actiLib Library 4U – Quick Start Guide
Page 7 of 21
3.3
Rack mounting the tape Library
The Library easily installs into a standard 19” rack system taking up 4U of space.
The actiLib Library 4U weighs 24,5 kg without media
WARNING
Weight!
Risk of personal injury or damage to the Library.
always remove all tapes to reduce the overall
weight of the Library
obtain adequate assistance to lift and stabilize
the library during installation or removal
observe local health and safety requirements
and guidelines for manual material handling
Required tools:
#3 Phillips screwdriver
T10 Torx screwdriver
There are two sets of eight M6 screws in the accessory package that came with your Library. The type
of rack that you have will determine the type of M6 screw that you will use.
To install the Library:
3.
Determine the location in you rack for your Library to be installed and, using a pencil, mark the
location on each vertical rail in you rack.
4.
Using the appropriate M6 screws for your rack type, and a #3 Phillips screwdriver, secure one rail
to each side of the rack in your chosen rack location. Secure both the front and back of each rail to
the rack. The rails extend to fit a variety of rack depths. The correct orientation of the left and right
rails is shown in Figure 3.
Figure 3 Installing the rails into the rack
1.
Using the Torx screwdriver, remove the screw on each side of you Library. Shown in
Figure
4
step1.
