www.acti.com
Hardware Manual
14
4.
Let the network cable with RJ-45 head pass through the rubber (use the rubber plug to
ease the insertion of RJ-45 connector through the hole).
5.
Insert other cables, like power or relay input / output devices, as needed, using the other
cable hole rubber plug. Use the supplied terminal blocks to connect other devices. See
on page 18 for detailed instructions. Although the steps below show
only the network cabling, similar procedures can be applied to other cables.
6.
Route the cables through the gap of the bracket and then through the cable hole of the
camera back cover.
7.
Connect the network cable to the Ethernet port on the camera. When done, replace the
rubber gland(s) into the holes of the back cover.
