www.acti.com
Hardware Manual
12
Installing the Camera
This section describes the procedures in mounting the camera on a flat surface, such as wall
by the doorway, with the use of the bundled mounting plate. This installation requires access to
the back of the surface.
NOTE:
The following pictures are for reference only.
Step 1: Prepare for Installation
1.
Attach the bundled drill template sticker on the target installation surface.
2.
Drill the screw holes and cable hole, as needed.
3.
Remove the drill template.
4.
Using the bundled hex screw driver, remove the two hex screws on the bottom of the
camera to separate the mounting plate from the camera.
5.
Install the mounting plate on the wall using the four bundled screws and plugs.
