www.acti.com
ENR-2000 Series System Administrator’s Manual
18
Installation
The installation procedures may vary depending on your site conditions. The procedures
provided in this manual are based on an example condition consisting of (1) local network, (2)
an ENR unit, (3) ACTi network cameras, (4) a POE network switch and (5) necessary
peripherals.
Prepare the Devices
Before starting connecting all the devices together, please read the instructions below to
make sure your devices are ready for ENR system.
Cameras
ENR is able to automatically add the connected cameras then immediately displays their live
streams without your further configurations. It is strongly recommended that you return the
camera settings back to factory default beforehand. Otherwise, please fulfill the conditions
below to make sure your cameras are prepared for ENR
Auto Add
function:
1.
For cameras whose settings have been changed from factory default, please make
sure the camera output stream
’s
encoder type is H.264
, (2
) the camera’s IP address
falls in the same network range with ENR
LAN1
port:
192.168.0.10
or
LAN2
port
(DHCP).
2.
Individually configure other camera properties
via camera’s web configurator with
another PC if required, for example, the
Video
Motion Region Settings
,
Stream
Mode
, etc.
3.
To have ENR automatically assign IP addresses to cameras via
LAN 1
port, make
sure the camera connection type is
Dynamic mode
(DHCP Client).
( ACTi camera web configurator interface)
