www.acti.com
Hardware Manual
17
Step 3: Route the Cables
Determine whether the cable will pass through a hole on the surface or be routed along the
surface:
If the cable will pass through a hole on the surface
:
1.
Drill the hole for the cable on the surface.
2.
Route the cable from the network side through the hole and connect it to the Ethernet port of
the camera.
NOTE:
If the camera will be installed outdoors or in places wherein environmental factors
change drastically, make sure to waterproof the cable connection; see
on page 19 for instructions.
3.
Push the cable through the hole on the surface.
If the cable will be routed along the surface
1.
Pull the rubber tab off from the base of the camera.
2.
Route the camera cable through this gap.
Drill cable hole
within this block.
