www.acti.com
Hardware Manual
17
Connecting Audio Devices (Optional)
Audio input / output devices, such as an active microphone or speaker can be connected to
the camera using the supplied terminal block which is already connected to the AUDIO cable
connector.
Loosen the screw and insert the wire through the pin slot, then tighten the
screw to secure the wire.
To connect audio devices, map the pins to one of the pin combinations
below:
Device
Pin
Mapping Instructions
Audio Output
(OUT)
OUT
Connect the wires of the audio output device to
OUT
and
G
(Ground).
G
Audio Input (IN)
IN
Connect the wires of the audio input device to
IN
and
G
(Ground).
G
The camera does not provide power for external devices. Use an external power source to
supply power when using LINE-IN microphones with the camera.
NOTE
:
For more information about AUDIO in connections, please refer to the Knowledge
Base article
How to Use Audio-In of ACTi Cameras
downloadable from the link below
https://Download.acti.com?id=534
After mapping the wires to the terminal block, connect the terminal block to the Audio
connector of the camera and make sure to protect the cable connection against water or other
environmental factors, such as by using a waterproof tape.
DISCLAIMER:
ACTi will not be responsible for camera damage due to water leakage caused
by improper waterproofing of cables.
