INSTALLATION MANUAL
4
4.
Confirm and acknowledge camera function by pressing
Continue
. If the camera is
not functioning properly, you will have to replace the camera and begin again.
5.
Once the in-car service is complete, the handset will display
“Install Complete
Connect to PC”
. Disconnect the handset and proceed to the PC/ITE service
outlined in section 16.4 of the LR installation and services manual (60-000249).
SETTING THE OPTIMUM CAMERA ANGLE
1.
After the PC/ITE installation procedure is complete and the handset reconnected,
remove the vehicle from the garage.
2.
Position the client in the driver’s seat.
3.
Pivot the camera left and right at the base to centre the driver’s head horizontally
as in Fig.1. Confirm the correct position via the live feed on the handset screen.
4.
Tighten the two (2) screws in the base to lock-in the angle.
5.
Pivot the camera face up and down to position it so the driver’s crown (top of the
head) is just below the top of the picture (as in Fig. 1). Confirm the correct position
via the live feed on the handset screen.
6.
Tighten the two (2) screws at either side of the camera head to lock-in the angle.
7.
Approve the image by pressing the Left button.
8.
Insert tamper-proof plugs to cover the angle adjusting screws on the base and on
the sides.
9.
Complete the handset activation procedure.
Fig. 1: Subject positioning
Midline guidelines
Client
image
Handset
screen
Summary of Contents for ALCOLOCK Focus
Page 1: ...Installation and services manual ALCOLOCK Focus TM...
Page 11: ......
Page 12: ...INM ENG 60 000619 C 2014...
