ACS ALCOLOCK Focus, Installation And Service Manual

Page: 6 / 12

ALCOLOCK FOCUS 3
CAMERA INSTALLATION
WIRING
1. Strip 1-2 cm (1/3” – 5/8”) off the wire ends of the ALCOLOCK Focus camera’s
Power Harness Cable (13-001143).
2. Connect the BLACK wire to a ground source (GND).
3. Connect the RED wire to a source of 12V DC.
4. Connect the YELLOW (CANH) wire from the ALCOLOCK FOCUS camera Power
Harness Cable to the YELLOW-RED wire from the ECU Harness Cable
(13-001102).
5. Connect the BLUE (CANL) wire from the ALCOLOCK Focus camera Power
Harness Cable to the BLUE-WHITE from the ECU harness cable.
6. Solder and seal heat-shrink (94-000251) over each soldered connection once the
camera has been tested and confirmed to be functioning.
7. Insert the USB end of the ALCOLOCK Focus camera Power Harness Cable wire
to the back of the camera. Tighten the tamper-proof screw and place seal over top.
MOUNTING CAMERA
1. Locate a flat area suitable for camera mounting where the camera will not obstruct
the view of the driver.
2. Use alcohol wipes to clean the mounting area thoroughly.
3. Peel the backing off one side of the double-sided adhesive and stick it to the base
of the camera.
4. Peel the backing off the other side of the double-sided adhesive and secure the
camera to the prepared mounting location.
HANDSET INSTALL PROCEDURE WITH CAMERA
NOTE: The process detailed below should be completed concurrently with the “HS Install
Procedure and ITE Install Transaction” process described in section 16.0 of the LR
installation and services manual (60-000249).
1. In the SERVICE menu, scroll to the Install option by pressing Prev or Next , then
press Select .
2. The screen will display Do you want to install camera? Press Yes .
3. Continue with the steps of a standard install procedure. At the end of the
procedure, the LR screen should display a live feed from the ALCOLOCK Focus
camera.