BioSIMKey - ADT60 Reference Manual
rev 1.0, April, 2002
Advanced Card Systems Ltd.
Page 24 of 26
APPENDIX B: RESPONSE STATUS CODES
The following table summarizes the possible status code bytes SW1, SW2 returned by the
BioSIMKey:
SW1
SW2
Status
90
00
OK – command successfully executed
90
01
OK – using T=1 protocol (only in response to the RESET command)
90
10
OK – synchronous protocol is used (only in response to the RESET command). The exact
card type should be selected by using the SELECT_CARD_TYPE command.
60
01
No card type selected
60
02
No card in reader
60
03
Wrong card type specified
60
04
Card not powered up;
This status code is also returned in a response if the card was temporarily removed during
a card access.
60
05
Invalid Instruction Code
60
20
Card failure
60
22
Short circuit at card connector
62
01
Secret code verify failed
67
01
Command incompatible with card type
67
02
Card address error
67
03
Data length error
67
04
Invalid length of response (with READ command)
67
05
Secret code locked
67
12
APDU command aborted (only MCU-based card using T=1 protocol); the command
abortion may be caused by a card internal failure.
