XVME-6300
6U VME Intel i7 Core Processor Board
Acromag, Inc. Tel: 248-295-0310
- 15 -
www.acromag.com
When SW1-1 and SW1-2 are both OFF, The SVME-6300 uses the BG3IN_ signal to enable a board to determine if it is
in VMEbus slot 1. If the board is in VMEbus slot 1, the BG3IN_ signal is low and the SCON function is enabled. If the
board is not in VMEbus slot 1, the BG3IN_ signal is high and the SCON function is disabled.
SW1-3 controls whether a local board reset drives out onto the VMEbus. When SW1-3 is ON the VME SYSRST# line
will be driven low to reset the VMEbus whenever the XVME-6300 is reset locally. When SW1-3 is OPEN the VMEbus
will not be reset.
SW1-4 controls whether the VMEbus can reset the XVME-6300. When SW1-4 is ON the XVME-6300 will be reset
when the VME SYSRST# signal is driven low. When SW1-4 is OFF the XVME-6300 will not respond to a VME SYSRST#.
Connectors
This section provides pin outs for the non-standard connectors on the XVME-6300. Refer to the EMC warning at the
beginning of this manual before attaching cables.
FPANEL
The FPANEL connector ports (USB1, USB2, COM4 and VGA) can be accessed through standard connectors by
using the supplied FPANEL dongle cable (P/N 201157). Note that the DB-9 serial connector on this dongle
cable is wired as a DTE port.
1
GND
2
USB Port 0 +
3
USB Port 0 -
4
GND
5
+5V USB POWER
6
VGA DDC DATA
7
VGA RED
8
VGA GREEN
9
VGA BLUE
10
GND
11
USB Port 1 +
12
USB Port 1 -
13
GND
14
+5V VGA POWER
15
VGA DDC CLK
16
GND RED
