AP513 ACROPACK
USER
’S MANUAL
Acromag, Inc. Tel: 248-295-0310
- 15 -
http://www.acromag.com
- 15 -
www.acromag.com
1
N.C. (WAKE#)
1
2
+3.3V
4
Note 1:
The following mini-PCIe signals are not supported: USB_D+, USB_D-, WAKE#,
LED_WPAN#, LED_WLAN#, LED_WWAN#, W_DISABLE#, COEX1, COEX2,
UIM_C4, UIM_C8.
Note 2:
UIM_PWR, UIM_RESET, UIM_CLK, UIM_VPP, UIM_DATA
–
SIM card for cell
signals may be available on some AcroPack carriers. See carrier
documentation for more information.
Note 3:
+5, +12, and -12 Volt power supplies have been assigned to pins that are
reserved in the mini-PCIe specification. Use of fuses on these power supplies,
along with new Present signal on pin 45, to allow support of mini-PCIe cards
from other vendors that cannot tolerate power applied to these reserved
pins. The Present signal must be grounded on the AP modules. The +12V, -
12V, and +5V voltages are needed to power the proposed Analog AcroPack
modules.
Note 4:
All +3.3Vaux power pins are changed to 3.3V power.
Note 5:
The SM bus signals SMB_CLK and SMB_DATA will be used to clock a carrier
location serial stream from the carrier, however this is not supported on the
AP513 module.
Note 6:
TDI is tied to TDO on the AP513 module as it does not use JTAG.
