Acrobat M24, Manual

Page: 8 / 18

8
6– Machine Assembly
Place the base flange of machine in such a way to fit table connection holes. Make sure you tighten bolts after
you place them with suitable Allen wrench.
WARNING! Make sure the connection surface of table is clean.
The smallest defect here (burr, small metal pieces) will prevent your machine to work vertically to
ground. After you place the bolts, remove package bands and uncover the machine.
To make machine adjustment for 90 degrees (See Picture-1) loosen bolts with number 1 and number
2 as in the picture (2 bolts facing each other). So that front head group will become free.
Press the mouth to which safe tap holder is connected,firmly on the surface you want to carry out
tapping. (PICTURE 4/ 90 degrees of leaning mouth) Tighten bolts with number 1 and number
2 again after surface leans. Make sure surface leaning does not change during the process of
tightening bolts. In that way 90 degrees adjustment of your
machine will be done.
YOUR MACHINE IS SENT AFTER THE ADJUSTMENT IS MADE
FOR 90 DEGREES.
1
2
3
4
Base Flange
Picture –1
Hardness adjustment mechanism which allows lifting its weight is available on the acrobatic arm.
[See Picture 1) Front parallel arm group hardness adjustment can be done via handle with number 3 as
seen on the picture, and handle with number 4 is used for rear parallel arm group's hardness
adjustment.