Acrobat M24, Manual

Page: 11 / 18

11
7– Machine’s Operation
The transmission range of the machine is double-stage, and your tapping between M5 and M14 works at
600 rpm (decelerating as the tooth grows from the precision speed limiter) in the first run, while tapping
between M16 and M24 at 150 rpm by slowing the tooth as it grows). ATTENTION ! You have to work in the
2nd level from M16. Otherwise, the hydraulic system and the transmission system may be damaged.
Otherwise, your machine will be out of warranty. Step transitions are made with the step transition song on
the left side of the front double-step gearbox group. M5-M16 is available when the dot on the stage song is
in the upper level (1st slot), and M16-M24 when the lower slot (2nd slot) is on. In order to make the
transition, you must rotate the song with your hand to sit in the nest. When switching between stages,
turning the work shaft slightly to the left or right during turn turning will help keep the gears in place.
If you put the finished tapping holders in the lower tapping holders, you have prevented possible
accidents.
Once you are done with the machine, press the engine stop (red button) button on the unit. And turn off
pako shawl. When you are not working with the machine, leave the acrobatic arm in the closed
position.
Picture 5