Page 21
AB-G200L-REM-I01-150914
Pairing the handset to the Fire control unit
With 2 good quality AA alkaline batteries in the handset in
the direction shown inside, if the handset can be paired
with a control, it will have the display with the word TESC
on the display as shown over leaf.
The handset must be within 1 metre (3 feet) of the fire
when pairing
After fitting the batteries and with the
power
isolator
slide switch on the Control unit slide to the on position (I),
simultaneously press and hold the – and + buttons on the
Fire control unit (i.e. not the handset) until the red light
comes on. Then immediately release the buttons and
press the ON/OFF button on the Control Unit. The
handset makes a noise and the display shows the pattern
as shown to the right.
Hold the handset in one hand so your fingers wrap around
the back of the operating buttons area of the handset. A
green unlock light will illuminate when the handset has
detected your hand. The green light must be illuminated
in this way for any of the command buttons to accept
commands to operate the fire control.
While the display is as shown, and holding the handset as
described, press the SET button with the other hand to
finish off the pairing of the handset to the Fire Control.
You can then enter the setup and set the time of day on
the handset. As shown earlier in the instruction
N.B. If the display returns to the one shown above with
the word “TESC” shown, then too much time has passed
before pressing “SET” and so the handset has not paired
yet. Simply repeat pairing again.
N.B. Only ever press + and - buttons together when
pairing handsets. If done afterwards this will break the
pairing made and a factory reset of the handset will need
to be performed See
Factory Reset of display handset
Summary of Contents for BLOOMSBURY
Page 24: ...Page 24 AB G200L REM I01 150914 ...
Page 25: ...Page 25 AB G200L REM I01 150914 ...
