PREPARATION
WARNING:
Always use handle to lift pump. Never use power cord to lift pump. To avoid skin
burns, unplug and allow time for the pump to cool after periods of extended use.
Estimated Assembly Time (New installation): 30 minutes (or longer if installing new sump pit).
Materials Required for Assembly (not included): Flexible connector, Check valve, PVC pipe,
PVC elbow, Thread Tape, PVC Purple Primer, and PVC Cement
INSTALLATION INSTRUCTIONS
1. Normal discharge for this pump (A) is 1-1/2 in. However, if existing 1-1/4 in. discharge pipe is already
in place, wrap the threads of the 1-1/4 in. adaptor (included) with thread
tape and thread into pump discharge.
Install a sump pump check valve (not included) into the pump (A).
2.
Connect a flexible connector (not included) to the check valve.
3.
Tools Required for Assembly (not included): Wrench, Phillips screwdriver
Place the pump (A) in the sump pit. Make sure that nothing interferes with
the float switch operation.
4.
NOTICE:
Remove all small stones, gravel, mud, or other debris from the
sump pit before installing the pump (A). The minimum diameter of the
sump pit is 14 in. The minimum depth of the pit is 16 in. Construct the
sump pit with tile, concrete, steel, or plastic. Check your local plumbing
codes for approved materials and proper installation.
A
B
A
A
1
2
3
A
4
