PuliMATIC - ENGLISH
MAN141 PAGE E-15
1-
Access the diagnostics page
Press
sequentially and hold the pressure for 7
seconds on the indicated buttons
2.1-
Manual step mode operation of the gearmotor
Press
repeatedly to operate the gearmotor in step
mode
2.2-
Manual continuous mode operation of the gearmotor
Press
hold the pressure to operate the gearmotor in
continuous mode
3-
Solenoid valves enabling/disabling (Optional)
Press
to activate the solenoid valve (ON) or
deactivate it (OFF)
3-
Confirm settings
Press
to confirm and exit the diagnostic page
If the filter is not in the correct position when exiting the diagnostic page, the gearmotor will start to
rotate until the system reaches the original filtration position.
A3 TROUBLESHOOTING
Anomaly
Cause
Solution
Upon water delivery
request, water pressure
drops considerably
Filtering element dirty
Perform a washing
The filter does not react
when buttons are pressed
Voltage interrupted
Check the power supply
Power supply unit defective
Replace the power supply unit
Electric circuit not working
Replace the electrical circuit
ALARM flashing message
on the display alternating
with the interior lighting
The filter is out of order
Set the equipment to the by-
pass mode
Disconnect and connect again
the filter power supply in order
to reset the alarms
If necessary, contact the service
center
The filter keeps performing
washing procedures
If present: Differential switch
blocked
Contact the service center
Leakage of water from the
filter drain
The drain valve is out of phase Contact the service center
