ACP XpressChef JET514A, Service Manual

Page: 10 / 41

10
INSTALLATION
IMPORTANT
ACP, Inc. Requires Installing a Type D Circuit Breaker for all High-Speed Xpress Oven Installations.
Unpacking Oven

Inspect oven for damage such as dents in door or dents inside oven cavity.

Report any dents or breakage to source of purchase immediately. Do not attempt to use oven if damaged.

Remove all materials from oven interior.

If oven has been stored in extremely cold area, wait a few hours before connecting power.
Radio Interference
Microwave operation may cause interference to radio, television, or similar. Reduce or eliminate interference by doing the
following:

Clean door and sealing surfaces of oven acco
rding to instructions in “Care and Cleaning” section.

Place radio, television, wireless routers, etc. as far away as possible from oven.

Use a properly installed antenna on radio, television, etc. to obtain a stronger signal reception.
Oven Placement

Do not install oven next to or above source of heat, such as pizza oven or deep fat fryer. This could cause oven to operate
improperly and could shorten life of electrical parts.

Do not block or obstruct oven filters. Allow access for cleaning.

Install oven on level counter-top surface.

If provided, place the warning label in a conspicuous place close to oven.

Outlet should be located so that plug is accessible when oven is in place.
Oven Clearances

Allow at least 4” (10cm) of clearance around top of oven. Proper air flow around oven cools electrical components. With
restricted air flow, oven may not operate properly and life of electrical parts is reduced.

There is not an installation clearance requirement for the back of the oven.

Allow at least 1’ (2.5cm) of clearance around sides of oven.

Install oven so its bottom is at least 3 feet (91.5cm) above the floor.