ACP OMNISTIM FX2, Patient User Manual

Page: 11 / 21

OMNISTIM ® FX 2 PORTABLE PENS PATIENT USER MANUAL - 9 -
COPYRIGHT © 2008 - 2021, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED
Patient Operational Sequence
Follow the sequence below. The number in parenthesis references the location of the
button from the control section on the previous page.
1. Install battery in compartment located on the back of the unit (9).
2. Connect lead wires to corresponding bar code under the display window (green lead
wire in the left input (6), blue lead in the right input (7).
3. Wash the skin with water, (use soap if dirty).
4. Connect black unit lead wires to white electrode wires.
5. Press the power on/off button (1) to power on the device.
6. At power on, the display (8) will default to the pre-set program selected for your
condition.
a. If a second program has been ordered by your physician, press Program
Button B (3) to access the additional program.
b. To return to the first program, press Program Button A (2).
7. Apply electrodes to treatment area prescribed by your physician or therapist.
8. Adjust stimulation intensity to level prescribed by your physician or therapist.
a. Increase / decrease (4) Output A. Press (+) button to increase intensity in
channel A. Press the (-) button to decrease intensity in channel A.
NOTE:
If the channel indicator flashes or you see this symbol you must
reset the output level. (See troubleshooting section).
Attention/Caution
b. Increase / decrease (5) Output B. Press (+) button to increase intensity in
channel B. Press the to decrease intensity in channel B. See note above.
NOTE: Shortly after reaching the desired intensity setting, the unit will
lock the setting preventing an accidental increase in the intensity. A lock
icon will be indicated on the display. To unlock, you must first press the (-
) button to decrease the intensity, and then press the (+) button to increase
the intensity to the new desired level. If you see the reset output symbol
you must press (-) button to decrease the intensity, and then press the (+)
button to increase the intensity to the new desired level.
Lock Decrease