12
OMNISTAND™ USER MANUAL
COPYRIGHT © 2016, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED.
OPERATIONAL GUIDELINES
Unpack OmniStand™
Remove OmniStand™ from packaging
Check OmniStand™ for all accessories/options and for transport damage
Check if delivery is complete
Inform supplier or forwarding agent immediately about any damage
Exercise Program Planning
The frequency and duration of exercise sessions on the OmniStand™ should be individually planned based on each
exerciser’s health profile, status, and condition. Proper exerciser-specific exercise dosing with the OmniStand™ is
extremely important if improvements in balance, mobility, strength, cardiovascular performance, and endurance are
to be achieved. It is recommended that relative to exerciser-specific needs and capabilities, exercise sessions start at
an easier intensity and shorter duration. As exercisers demonstrate better exercise tolerance, progressive increases in
intensity and/or duration are recommended, dependent on each user’s goals and health status.
Basic Operational Sequence
Caution
Risk of injury due to insufficient preparation!
Before starting any exercise, make sure that the OmniStand™
is properly assembled, and
fully operational.
Disinfect the OmniStand™
before every training.
Note: Markings on upper pipe frame and knee support simplify horizontal adjustment. Before every exercise
session, adjust settings of OmniStand™ to match the user's individual needs.
Lock transport castors with brake/wheel locks
Prevent OmniStand™ from moving as follows:
Before EVERY USE, lock all four transport castors with brake/wheel locks
Push down locking lever on transport castors with brake/wheel locks
Release transport castors with brake/wheel locks
To transport OmniStand™:
Release locking lever on transport castors with brake/wheel locks
Setting the height of the upper pipe frame
Note:
A pneumatic spring supports the height adjustment
Release winged screw B on first vertical pipe
Set height using marks A
Tighten winged screw B on first vertical pipe
Repeat process to set height on second vertical pipe
Make sure that height settings of left and right
vertical pipe are the same
A
B
