©2019 ACP, Inc.
Cedar Rapids, IA 52404
Page 5 of 22
Part No. 20267401
Original Instructions
Grounding/Earthing Instructions
Oven MUST be grounded.
Grounding reduces risk of electric shock
by providing an escape wire for the electric current if an electrical
short occurs. This oven is equipped with a cord having a grounding
wire with a grounding plug. The plug must be plugged into an outlet
that is properly installed and grounded.
Consult a qualified electrician or servicer if grounding instructions are not completely understood,
or if doubt exists as to whether the oven is properly grounded.
Do not use an extension cord.
If the product power cord is too short, have a qualified electrician install a three-slot receptacle. This oven should be plugged
into a separate circuit with the electrical rating as provided in product specifications (available at www.acpsolutions.com) and
the oven’s serial plate / rating label. When the oven is on a circuit with other equipment, an increase in cooking times may be
required and fuses can be blown.
EXTERNAL EQUIPOTENTIAL EARTHING TERMINAL
(export only)
Equipment has secondary earthing terminal. Terminal provides external earthing connection used in addition to earthing
prong on plug. Located on outside of oven back, terminal is marked with symbol shown at right
Installation
Unpacking Oven
• Inspect oven for damage such as dents in door or inside oven cavity.
• Report any dents or breakage to source of purchase immediately.
Do not attempt to use oven if damaged.
• Remove all packing materials from oven interior.
• If oven has been stored in extremely cold area, wait a few hours before
connecting power.
Radio Interference
• Microwave operation may cause interference to radio, television. Reduce or
eliminate interference by doing the following:
•
Clean door and sealing surfaces of oven according to instructions in “Care and
Cleaning” section.
Oven Placement
• Do not install oven next to or above source of heat, such as pizza oven
or deep fat fryer. This could cause oven to operate improperly and could shorten
life of electrical parts.
•
Do not block or obstruct oven filters. Allow access for cleaning.
• Install oven on level counter-top surface.
OVEN CLEARANCES
A.
Allow at least 2” (5.1 cm) of clearance around top of oven. Proper air flow around
oven cools electrical components. With restricted air flow, oven may not operate
properly and life of electrical parts is reduced.
B.
General market models:
There is not an installation clearance requirement for the
back of the oven.
HDC21RB2, MCHDC21, HDC21DQ only:
Allow at least 1” (2.54 cm) of clearance
around back of oven.
C. Allow at least 1” (2.54 cm) of clearance around sides of oven.
D. Install oven so oven bottom is at least 3 feet
(91.5 cm) above floor.
⚠
WARNING
Excessive Weight Hazard
Use two or more people to move
and install oven. Failure to do so can
result in back or other injury
⚠
WARNING
To avoid risk of electrical shock or
death, this oven must be grounded
and plug must not be altered.
Grounding and Installation
A
B
C
D
A
D
B
C
A
B
C
D
A
D
B
C
