ACME Zoopa 350, Instruction Manual

Page: 18 / 36

18
zoopa 350
EN
G
LI
SH
BC4024 2.4 GHZ CONTROLLER
Beginner/Professional Mode
Gas Trim
Gas,Roll Stick
Roll Trim
On/Off Switch
Antenna
Power Indicator
Forward/Backward Trim (Nick)
Forward/Backward, Left/Right Control
Left/Right Trim (Sheer)
At the backside of the controller, there is the Reset Button located next to the battery compartment.
CHARGING THE HELICOPTER
»
To charge the LiPo battery, connect the power adaptor with the charger.
»
Connect the white balancer plug with the charger port.
»
Charging takes, depending on the battery condition, up to one hour. The LED flashes green when the battery is fully charged.
Always!follow!the!safety!instructions!of!this!manual!when!charging!the!battery!(Chapter:!Safety!Advice!S.!25).
BINDING THE CONTROLLER WITH THE HELICOPTER
Perform the binding process as followed:
»
Insert 8 AA 1,5V batteries into the controller.
»
The helicopter needs to be switched off! Connect the battery plugs.
»
Place the helicopter on a plain surface and let the tail rotor point into your direction.
»
Switch ON the helicopter.
»
Pull the gas stick of the controller towards the lower left corner and hold it while you switch on the controller.
»
A minimal servo reaction of the helicopter is being heard.
»
Put the gas stick into neutral position.
»
Switch OFF the controller.
»
Leave the helicopter turned ON.
»
Get 3 meters away from the model and switch ON the controller again.
»
Done!