7. Troubleshooting
Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
A. The fixture does not work, no light
1.
Check the connection of power and main fuse.
2.
Measure the mains voltage on the main connector.
B. Not responding to DMX controller
1.
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
2.
If the DMX LED is on and no response to the channel, check the address settings and DMX
polarity.
3.
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
fixture or the previous one.
4.
Try to use another DMX controller.
5.
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.
C. One of the channels is not working well
1.
The stepper motor might be damaged or the cable connected to the PCB is broken.
2.
The motor’s drive IC on the PCB might be out of condition.
8. Fixture Cleaning
Cleaning must be carried out periodically to optimize light output. Cleaning frequency depends on
the environment in which the fixture operates: moist, smoky or particularly dirty surroundings can
cause a greater accumulation of dirt on the fixture.
Clean with soft cloth using normal glass cleaning fluid or mild soapy water.
Always dry the parts carefully.
Clean the external optics at least every 30 days.
11
Summary of Contents for LITE PANEL 900 LP-900 CW BD30
Page 1: ...LP 900 WW BD30 LP 900 CW BD30 User Manual Please read the instructions carefully before use...
Page 7: ...6...
Page 13: ...12...
Page 14: ...13...
