LED-HC101 II
A. DMX address setting by dip-switches
1. Set the start address by dip-switch as the diagram below
2. Hold the AUTO DMX ADDRESS button for about 5 seconds, the LED
lights blinking indicating the address is set successfully.
Dip
# 1
# 2
# 3
# 4
# 5
# 6
# 7
# 8
# 9
# 10
Value
1 2 4 8 16
32
64
128
256
Master/Slave
•
Examples:
Channel 01
：
dip / on : # 1
（
=1
）
Channel 05
：
dip / on : # 1, # 3
（
1+4=5
）
Channel 09
：
dip / on : # 1, # 4
（
1+8=9
）
Channel 13
：
dip / on : # 1, # 3, # 4
（
1+4+8=13
）
B. Auto DMX addressing
1. The DMX address of fixture can be set automatically. Set all dip-switches to OFF
and hold the
AUTO DMX ADDRESS
button of the first unit for about 5 seconds,
the fixture will be set the DMX start address to 1, and the other fixtures of the
chain will be set their own DMX start address automatically.
2. The LED fixtures use four channels, the next fixture’s will be automatic calculate
their own DMX address, not need to calculate the DMX channels of each fixture
in the chain. (Fixture 1 = 1, Fixture 2 = 5, Fixture 3 = 9, Fixture 4 = 13, Fixture…)
3. No need to turn the fixture off when you change the DMX address, as new DMX
address setting will be effect at once. Every time you turn the fixture on, it will be
ready to receive DMX signal or run the built-in programs.
LED-HC101 II
C. Remote DMX address setting by CA-T DMX TESTER
The fixture can be set the DMX address remotely by CA-T
DMX TESTER
. Please
refer to the CA-T user manual to set the DMX address to the fixture.
D. Remote DMX address setting by universal DMX controller
y
Make sure the DMX cables of all units are connected.
y
Connect the first unit to a universal DMX controller.
y
Connect all units to the mains so they are switched on.
y
Set all DMX-channels on your DMX-controller to zero (value 000).
y
Set the DMX-channel, that you want to assign as DMX start address on you unit,
to maximum (value 255).
y
Press the “Auto DMX address” button on the unit shortly.
y
If you want to set another unit to the same DMX start address, simply press it’s
“Auto DMX address” button and it will receive the same address.
y
Done!
An example to make things clear:
y
We will set the DMX start address of a unit to 106:
y
Connect the unit to the DMX-controller as described above and make sure all is
switched on.
y
Set all DMX-channels on the controller to zero (000).
y
Now set DMX-channel 106 to maximum (255).
y
Press the “Auto DMX address” button on the unit shortly.
y
Done! Your unit now has DMX address 106!
5A
6A
