11A
7. DMX512 Connections
The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels.
1. Connect the fixture together in a “daisy chain” by XLR plug cable from the output of the
fixture to the input of the next fixture. The cable cannot be branched or split to a “Y”
cable. Inadequate or damaged cables, soldered joints or corroded connectors can
easily distort the signal and shut down the system
2. The DMX output and input connectors are pass-through to maintain the DMX circuit
when one of the units’ power is disconnected.
3. At last fixture, the DMX cable has to be terminated with a terminator to reduce signal
errors. Solder a 120-ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a
3-pin XLR-plug and plug it in the DMX-output of the last fixture.
4. Each lighting fixture needs to have an address set to receive the data sent by the
controller. The address number is between 0-511 (usually 0 & 1 are equal to 1).
5. 3 pin XLR connectors are more popular than 5 pins XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+),
Pin4/5: not used
4A
4. How toset the unit
4.1Rear Panel
!
1
Display:
To show the various menus and the selected functions
LED:
!
2 DMX
On
DMX input present
!
3 MASTER On
Master Mode
!
4 SLAVE
On
Slave Mode
!
5 SOUND
Flashing
Sound activation
Button:
!
6 MENU
To select the programming functions
!
7 DOWN
To go backward in the selected functions
!
8 UP
To go forward in the selected functions
!
9 ENTER
To confirm the selected functions
!
10
Microphone
"
Receive music for the sound active.
!
11
DMX input:
For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal.
!
12
output
"
For DMX512 link, use 3/5-pin XLR plug cable to link the next unit.
!
13
Only for remote control
"
By connect to the 1/4’’ microphone jack to control the unit for
Stand by, Function and Mode function.
!
14
Safety Ring
"
For attached the safety cable.
!
15
Mains output
"
Connect to supply mains power for the next unit.
!
16
Mains input
"
Connect to supply mains power.
