13A
9. Fixture Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning
frequency depends on the environment in which the fixture operates: damp, smoky or
particularly dirty surrounding can cause greater accumulation of dirt on the fixture’s optics.
!
Clean with soft cloth using normal glass cleaning fluid.
!
Always dry the parts carefully.
!
Clean the external optics at least every 20 days. Clean the internal optics at least every
30/60 days.
2A
Safety Introductions
WARNING
!
Please keep this User Manual for future consultation. If you sell the fixture to another
user, be sure that they also receive this instruction booklet.
!
Unpack and check carefully there is no transportation damage before using the fixture.
!
It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.
!
Disconnect main power before servicing and maintenance.
!
Maximum ambient temperature is Ta : 40
!
. Don’t operate it where the temperature is
higher than this.
!
In the event of serious operating problem, stop using the fixture immediately. Never try
to repair the fixture by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center. Always use the same type spare parts.
!
Do not connect the device to any dimmer pack.
!
Do not touch any wire during operation and there might be a hazard of electric shock.
!
To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain
or moisture.
!
The housing must be replaced if they are visibly damaged.
!
Do not look directly at the LED light beam while the fixture is on.
!
There are no user serviceable parts inside the fixture. Do not open the housing or
attempt any repairs by yourself. In the unlikely event your fixture may require service,
please contact your nearest dealer.
!
Due to the magnifying type lens, please keep the lens out of contact with direct sunlight.
Direct sunlight can cause heat to build up inside of the unit, which will seriously damage
unit.
Please read the instructions carefully which includes important
information about the installation, operation and maintenance.
For power supply, do not connect in series much more than 32 units, use
another mains supply for next 32 units.
