ACME Eventx 100, User Manual, Page: 4 / 32

Look over power wires carefully, replace immediately if there is any damage.
Install at least 0.5m away from the objects to be illuminated.
Don’t connect the device to any dimmer pack.
Make sure there are no flammable materials close to the unit while operating, as it is fire hazard.
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces.
Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.
The applicable temperature for Eventx 100 is between -40
℃
to 45
℃
. Don’t operate it where the temperature is lower
or higher than this.
The exterior of the fixture becomes hot during use. Avoid contact by persons and materials. Allow the fixture to cool
for at least 10 minutes before handling.
For temporary installation with clamps, ensure that the quarter-turn fasteners are turned fully and secured with a
suitable safety cable.
Use safety chain when fixes the unit specially when the fixture is working at height. This safety chain must be approved
for a safe working load of 10 times the weight of the fixture, and it must have a minimum gauge of 2 mm.
Ensure that any supporting structure used can hold at least 10 times the weight of all devices they support.
Unit surface temperature may reach up to 80
℃
. Don’t touch the housing bare-hand during its operation.
Do not look directly at the LED light beam while the fixture is on.
Do not operate the fixture with missing or clamaged of any part of the device.
3 - Installation
This product contains a sophisticated optical system which can cause damage the led if the front glass is expose to
sunlight or other strong light source.
So if these light source hits the front glass, sheild it or point the head in the opposite direction to the light source.
3.1 Connection to the main
If you use EventX 100 with his charger, ensure that the voltage and frequency of power supply match the power
requirements of the charger.
Input Charger: 100-240 Vac 50/60Hz
Output Charger: DC 29.4 V 4A
The earth has to be connected.
If you have any doubts about proper installation, consult a qualified electrician.
2.2 Preventing burns and fire
2.3 Avoid personal injury
Exposition warning
Warning
3
A