11C
8. Repeat steps 3-7until all desired scenes have been
programmed into memory .Tap the Scanner button again to turn
off its fader control.To set another scanner(scanner), you may
tap the corresponding Scanner button to turn on its fader control,
then you may begin your programming again.
9. If you don't intend to continue your programming,
press and hold down the Program button for three
seconds to exit Program mode, the LED goes out
indicating this selection.
EXAMPLE: Program 8 scenes with channel 1-8 at full in sequence into
bank 3 and assign these scenes to scanner 1.
1. Program enable.
2. Tap the Scanner 1 button to turn on its fader control.
3. Tap the Page Select button to select Page A.
4. Push Fader 1 to the top position.
5. Tap the MIDI/Rec button.
6. Select bank 3 using Bank Up/Down button.
7. Tap the Scene 1 button to store the first scene.
8. Repeat steps 4-7 until all 8 scenes have been programmed into bank 3.
9. Tap the Scanner 1 button again to turn off its fader control.
10. Press the Program button for 3 seconds to exit Programming mode.
Page 9
3. Press the Mode and TAP/Display buttons at a time to store
your setting into memory.
If you are not going to save your setting, tap the Blackout
button to leave this operation.
4-4.4 Delete a scanner of DMX channels
1. Activate Assign or Reverse mode(Described in the
sub-chater 2.2.4.1 or 2.2.4.2).
2. Tap the Scanner button to select the scanner you wish to
delete.
3. Press the Mode and Auto/Del buttons at a time,all LEDs
should flash briefly, indicating the scanner is deleted.
4-4.5 Clear all DMX channels
1. Turn the power off.
2. Press the Mode and Auto/Del buttons at a time.
3. While pressing the two buttons, apply the power again, all
LEDs should flash briefly,indicating all assigned or reversed
DMX channel are cleared.
Page 22