16A
6. DMX Connection
1.
Connect the fixture together in a “daisy chain” by XLR plug cable from the output of the
fixture to the input of the next fixture. The cable cannot be branched or split to a “Y” cable.
2.
The DMX output and input connectors are pass-‐through to maintain the DMX circuit when
one of the units’ power is disconnected.
3.
The last units DMX cable has to be terminated with a 120 ohm 1/4W resistor between pin
2(DMX-‐) and pin 3(DMX+) of a 3-‐pin XLR-‐plug and plug it in the DMX-‐output of the last unit.
4.
Each fixture unit needs to have an address set to receive the data sent by the controller. The
address number is between 0-‐511 (usually 0 & 1 are equal to 1).
5.
3 pin XLR connectors are more popular than 5 pins XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-‐), Pin 3: Positive signal (+)
Pin 4/Pin 5: Not used.
Summary of Contents for Butterfly quard
