-4-
L
5. To change frequency crystals simply remove the black plastic crystal
holder from the back of your transmitter by carefully pulling it straight
out. Slide the crystal out of the holder and install the new crystal labeled
“ Tx”in its place. Then carefully align the two pins that extend from
the transmitter, and gently press it into place.
Do not force the crystal! The pins can easily be broken! Remove the
crystal from your receiver in the same careful manner using a pair of
needle-nose pliers and install the new “Rx”crystal in its place.
PLEASE NOTE:
It is very important that the crystal labeled “ Tx” is installed in the
transmitter and the crystal marked “ Rx”is installed in the receiver.
RUNNING MULTIPLE VEHICLE(related to AM FM transmitter use)
If you have some vehicles that would like to get a vehicle of their own or already have friends with
other vehicles that you will be racing, it is very important that you first check what frequency channe
your vehicle is on and confirm that none of your friends have the same frequency as yours. If you do
find that someone else is using the same frequency channel that you are, you must wait for them to
turn their transmitter and vehicle OFF or you may choose to change the frequency crystals in your
transmitter and receiver (so that you can run together at the same time without causing any radio
interference). Additional frequency cystal sets can be purchased separately and installed in a few
quick seconds.
While if you have our optional radio control system- 2.4G at hand, please read as following:
LEARNING THE OPTIONAL TRANSMITTER - 2.4G
You may use the following diagram to confirm the location and function of each of these features.
A. ON/OFF Switch: Controls power to the transmitter.
B. Steering Wheel: Steering the vehicle left and right.
C. Throttle Trigger: Contols the speed and the Forward/Reverse
direction of the vehicle.
D. Throttle Trim: Ajusts the neutral position of the throttle so
your vehicle responds correctly to the trigger.
E. Steering Trim: Adjusts the neutral position of the throttle so
your vehicle travels straight.
F. Throttle Reverse Switch: Reverses the forward/reverse direction
of the steering wheel.
G. Steering Reverse Switch: Reverse the left/right direction of
steering wheel.
H. Antenna: Transmits radio signals to your receiver.
I. Recharging Jack: you can charge the battery with your charger
if you are using rechargeable batteries in your transmitter.
Caution: You can not recharge Non-rechargeable batteries.
J. Battery Power Indicators: Signal when it is time to replace your
transmitter batteries when the red indicator lit.
K. Steering Knob: Adjusts the steering angle
L. Start button: Channel 3.
