CENTAURI-200 User Guide
VT-ENG-TMP-UG | Rev 1.1 | 31-Jul-19
Volansys-Confidential
Page 14 of 31
Table 2 Gateway Switch function
4.3 Gateway Initial setup
Follow below steps for initial Gateway setup
4.3.1 Gateway Setup with Wi-Fi
1.
Plug in power cable in DC power input port of gateway available on back panel.
2.
Plug-out Ethernet cable if it is plugged in.
3.
Power up the Gateway.
4.
After power up, Gateway will be in Access point mode. It will broadcast SSID =
C
entauriGateway_XXXX
(XXXX = Last 4 digit of MAC address).
5.
Observe the LED indication.
o
LED2 as solid RED indicates no internet connectivity if gateway doesn’t have valid Wi-Fi
credential or does not have LAN or LTE connectivity. Wi-Fi credential can be provided to
gateway through mobile application
o
LED1 as solid RED indicates Gateway is in Wi-Fi access point mode
o
Refer section
for more details.
4.3.2 Gateway Setup with Ethernet cable
1.
Plug in power cable in DC power input port of Gateway.
2.
Plug in Ethernet cable to Gateway Ethernet port.
3.
Power up the Gateway.
4.
Observe the LED indication.
o
LED2 as RED indicates no internet connectivity.
o
Refer section
for more details.
devices, rules and scenes)
