USER MANUAL 16-2090
Rev. 09/2017
Page 20 of 27
10.2 The indicator light on the standby button S1 comes on but no
image appears on the screen
•
Check that the sensor is properly connected to the control unit (if not, a color bar will be
displayed).
•
Check that the control unit on the camera is correctly connected to the monitor (cable in
good condition and plugs correctly when pushed in).
•
If the video channel has several components, connect the camera directly to the monitor
to verify that the problem is not with one of the peripherals.
•
Check that the monitor is in fact switched on, wired to the correct video input and that the
image settings are at the mid-point position (color, light and contrast).
•
Check the light source, the light cable and the endoscope.
10.3 The image is blurred and white all over
•
Check that there is no condensation on the lens.
•
Check that the sensor is not aimed at an object that is too bright.
•
Check the lens setup.
If there is no image or if the image is not displayed, unplug and re-plug your device or
reset the camera to the factory settings.
10.4 The image is extremely light or dark
•
Check that the BRIGHTNESS parameter is not at the maximum or minimum setting.
•
Check that the APERTURE used is not too wide or too narrow.
•
Check that the camera head is correctly connected to the control unit.
•
Check that the light intensity from the light source is not too low or too high.
•
Turn off and turn back on the control unit.
If the fault persists and it becomes necessary to return the camera to your distributor, be sure
to ship it in its original packaging after disinfecting it.
Similarly, it is advisable to return the camera in its entirety (control unit, sensor, lens, cables).
Kindly attach to the shipping order an explanation concerning the fault detected.
The equipment must be disinfected before it is returned for repair.
Please contact your distributor who will guide you through the return process.
