11
SET function
SET
OK
FRESH function( ) (some units) :
Active clean function( ) (some units) :
AP function( )(some units) :
Follow me function( ) :
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET
button to scroll through operation functions as follows:
Breeze away ( ) Active clean/Self clean ( ) Fresh ( ) Follow Me( )
AP mode ( ) Breeze away....
[ ]: Model dependent
*
*
*
*
The FOLLOW ME function enables the remote
control to measure the temperature at its
current location and send this signal to the
air conditioner every 3 minutes interval.
When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the
remote control(instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
When the FRESH function is initiated, the
Ionizer/Plasma Dust Collector(depending
on models) is energized and will help to
remove pollen and impurities from the air
.
,
,
,
,
,
,
,
,
If the memory feature is stopped,
OF
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the Follow
me function.
NOTE:
Press and hold Turbo button for
seven seconds to start/stop memory
feature of Follow Me function.
If the memory feature is activated,
On
displays for 3 seconds on the screen.
The Active Clean Technology washes away dust,
mold, and grease that may cause odors when it
adheres to the heat exchanger by automatically
freezing and then rapidly thawing the frost.
When this function is turned on, the indoor unit
display window appears “CL”, after 20 to 45
minutes, the unit will turn off automatically and
cancel CLEAN function.
This feature avoids direct air flow blowing on the
body and makes you feel indulging in silky
coolness.
NTOE:
This feature is available under cool,
Fan and Dry mode only.
Breeze Away function( ) (some units) :
Choose AP mode to do wireless network
configuration. For some units, it doesn’t
work by pressing the SET button. To enter
the AP mode, continuously press the LED
button seven times in 10 seconds.
