4-4
User’s Guide
4.1.4
Troubleshooting
If you can’t connect to a server, try the suggestions here, then turn to
page 14.
•
Make sure you’re using the drivers for this adapter. The driver
filename contains the letter B (for example, E100BODI.COM).
•
If you’re replacing an existing adapter, make sure the LINK
statement in your NET.CFG is correct for the new adapter. For
example, the LINK statement for a NetWare client should be:
LINK DRIVER E100BODI
•
Verify FRAME type in your NET.CFG file matches your server.
•
If setting up a server, check your LOAD and BIND statements.
•
Make sure the PCI slots are busmaster-enabled (see page 17).
•
Make sure adapter and hub duplex mode match. See page 11
for more information on duplex modes for the PRO/100 TX
adapter.
•
Make sure the network cable is securely attached to both the
adapter and hub port and the adapter LNK light is on.
•
At 100 Mbps, make sure you are connected to a 100BASE-TX
hub (not a 100BASE-T4).
•
Test the adapter.
•
Check the README files.
Summary of Contents for M9N System
Page 1: ...M9N System User s Guide ...
