33
Eng
lis
h
OSD Messages
Problems with the Projector
#
Condition
Message Reminder
1
Message
• Fan Fail - the system fan is not working.
• Projector Overheated - the projector has exceeded its
recommended operating temperature and must be allowed
to cool down before it may be used. Please check the
following message.
Please also check the dust filters if they are installed. If the
dust filter is clogged with dust, please clean it. Please refer to
"Cleaning and replacing the dust filters" for details.
• Replace the lamp - the lamp is about to reach its maximum
lifetime. Prepare to replace it soon.
#
Condition
Solution
1
The projector stops
responding to all controls
If possible, turn off the projector, then unplug
the power cord and wait at least 30 seconds
before reconnecting power.
2
Lamp burns out or makes a
popping sound
When the lamp reaches the end of its useful
life, it will burn out and may make a loud
popping sound. If this happens, the projector
will not turn on until the lamp module has
been replaced. To replace the lamp, follow the
procedures in the "Replacing the Lamp"
section.
