77 Altos G330 Installation Configuration Guide
install.
7.
At Prepare boot partition page, just select continue to use the DOS
partition we created.
8.
When you see the following message, please select Modify. Move the
cursor to Storage adapters and press Enter.
The following device drivers were detected for this
server. Add, change, or delete device drivers as
needed.
Device types Driver names
------------------------- ----------------------------
HotPlug Support Module: (optional)
Storage adapters: IDEATA ADPAHCI
9.
After you pressing the Enter, you would see the storage adapter detected
by NetWare 6.5 Support Pack 6. Please move cursor to ADPAHCI.HAM and
press Delete to remove the driver.
Add, edit, or delete storage drivers. Each
controller/adapter requires a driver.
Driver name Device Name Stat
------------ ------------------------------- ----
IDEATA.HAM Standard ATA/IDE/ATAPI Adapter
ADPAHCI.HAM Adaptec ICH 7R RAID Controller
10.
To apply the driver for onboard LSI SATA RAID, please press INSERT key
twice, insert the driver disk for onboard LSI SATA RAID into floppy and
press Enter.
11.
After the driver is successfully loaded, you would see the devices listed as
below. Then, please select Return to driver summary.
Add, edit, or delete storage drivers. Each
controller/adapter requires a driver.
Driver name Device Name Stat
------------ --------------------------------------- ----
IDEATA.HAM Standard ATA/IDE/ATAPI Adapter
MEGARIDE.HAM Intel Embedded Server RAID Technology
12.
You would see the following message. Please select Continue to continue
the installation.
The following device drivers were detected for this
server. Add, change, or delete device drivers as
needed.
