Chapter 3
75
LCD Module Disassembly Process
IMPORTANT:
Cable paths and positioning may not represent the actual model. During the removal and
replacement of components, ensure all available cable channels and clips are used and that the cables are
replaced in the same position.
NOTE:
The product previews seen in the disassembly procedures may not represent the final product color or
configuration. The following procedure outlines the steps to disassemble the LCD Module on models with 3G
functionality. Models that do not support 3G do not require the removal of the yellow and blue Antenna cables
detailed below.
LCD Module Disassembly Flowchart
Screw List
Step
Screw
Quantity
Part No.
LCD Bezel
M2*4
4
86.S6802.001
LCD Panel
M2*4
2
86.S6802.001
LCD Brackets
M2*3
6
86.S6802.003
Remove
LCD Panel
Remove
LCD Bezel
Remove
LCD FPC Cable
Remove LCD
Panel from Main
Unit before
proceeding
Remove
LCD Brackets
Remove
Antennas
Remove
Camera Module
Summary of Contents for AOD250
