SuperWorkstation 5039D-I User's Manual
Chapter 3: Maintenance and Component Installation
18
19
Load Plate
Load Lever
Figure 3-2. Removing the Processor Cover Plate
2. Gently lift the load lever to open the load plate. Remove the plastic cover plate.
Figure 3-1. Accessing the System
3.3 Motherboard Components
Processor and Heatsink Installation
Follow the procedures in this section to install a processor (CPU) and heatsink to the
motherboard.
Notes:
•
The motherboard should be installed into the chassis first and the processor should be
installed into the CPU socket before you install a CPU heatsink.
•
If you bought a CPU separately, make sure that you use an Intel-certified multi-directional
heatsink only.
•
When receiving a motherboard without a processor pre-installed, make sure that the plastic
CPU socket cap is in place and none of the socket pins are bent; otherwise, contact your
retailer immediately.
•
Refer to the Supermicro website for updates on CPU support.
Installing the Processor(s)
Begin by removing power from the system as described in Section 3.1.
1. Remove the cover plate that protects the CPU#1 socket. Lift the lever on the socket until
it points straight up. With the lever raised, lift open the processor retention plate.
Bottom Edge
Figure 3-3. Placing the Processor into the Socket
3. Use your thumb and your index finger to hold the edges of the processor. Align the CPU
key (the semi-circle cutouts) with the socket keys.
4. Once aligned, carefully place the processor into the socket. Do not drop the processor
on the socket, move or rub the processor against the socket or against any socket pins,
which may damage the components.
Top Edge
Cov
5
er
3
Handle (B)
2
Slide Tab A
Toward Handle
B
Release Tab
(A)
4
3
