Acer Altos BrainSphere P130 F7, User Manual

Page: 28 / 40

Initial system startup problems
Problems that occur at initial system startup are usually caused by an incorrect installation
or configuration. Hardware failure is a less possible cause. If the problem you are
experiencing is with a specific application.
Initial troubleshooting checklist

AC power is available at the wall outlet?

Is the power supply module properly installed?

Is the system power cord properly plugged into the power supply module socket? and
connected to a NEMA 5-15R outlet for 100-120 V or a NEMA 6-15R outlet for 200-240
V?

Are all peripheral cables correctly connected and secured?

Did you press the system power button to turn the Workstation on (power on indicator
should be lit green)?

Are all device drivers properly installed?

Are hard disk drive(s) properly formatted and configured?

Are the BIOS configuration settings in the BIOS Setup Utility correct?

Is the operating system properly loaded?
Refer to the operating system documentation.

Are all hardware components compliant with the tested components

lists?

Are all internal cables correctly connected and secured?

Is the processor properly seated in its mainboard socket?

Are all standoffs in the proper location and not touching any components, causing a
potential short?

Are all add-in expansion cards fully seated in their mainboard slots?

Are all system jumpers correctly set?

Are all switch settings on add-in boards and peripheral devices correct?
To check
these settings, refer to the manufacturer’s documentation that comes with
them. If applicable, ensure that there are no conflicts (e.g., two add-in boards sharing
the same interrupt).