1.First time charging :
Please fully charged the model SK-BTI-029 before using.
2.Charging in low power
When the red LED light is flashing in normal use, it indicates that the SK-BTI-029 is in low
battery mode and needs to be recharged(it is normal for the blue and red LED light overlap
when using in low power and charging while working)
A, Connect the charging cable to the charging adapter(with USB output connector) or to the
computer.
B, and then connect the Micro USB side to the SK-BTI-029.
C, The red LED light on whiling charging, red LED off when fully charged..
D, the charging time takes about 2 hours.
SK-BTI-029 working as transmitter function and LED instruction
SK-BTI-029 is through toggle switch to select the mode is transmitter or receiver mode
after powered on. In power off status, switch to “TX” end, and long press "multi-function
key" to power on, all paired device information will be cleared in RX mode after powered
on!!!Please don’t switch TX/RX mode within 3 seconds after powered off, because the
chipset has not been fully powered down, the mode is maybe still keep the same state as
before powered off if you switch the mode
.
SK-BTI-029 can store 4 devices information used as a transmitter, the exceed device
information will be replaced by new device information
（
why is store 4 ? Because the
SK-BTI-029 will re-connect all the paired devices after powered on, it will take long for
too many devices)
SK-BTI-029 automatically re-connection time : 7 seconds for the unit has 1 paired record,
12 seconds for the unit has 2 paired records ,17 seconds for the unit has 3 paired
records , 22 seconds for the unit has 4 paired records.
1.
Power on
In off state, press MFB around 3 seconds, Blue LED flashes twice, SK-BTI-029 is powered on.
(If SK-BTI-029 did not connect with any device, it could enter into pairing mode quickly with
Blue LED flashes after power on)
2. Power off :
In on state, press MFB around 3 seconds, Red LED flashes twice ( if release after Red LED
immediately, Red LED may only flashes once), SK-BTI-029 power off. Please re-power on the
unit after power off the unit 3 seconds later since the voltage of the chipset may not disappear
totally.
3. Pairing mode :
Power on the unit, double click the MFB, the Blue LED flashes quickly to enter pairing mode.
4. Clear up the pairing list :
Power off with the current working mode(TX or RX), 3 seconds later, switch to the other
working mode, then power on, the pairing information for the former mode will be cleared up.
5.Re-connect with all the connected device:
