1. Put the Bluetooth headset or Bluetooth speaker into pairing mode. Then power on SK-BTI-
029 will connect to SK-BTI-029 quickly again, if the Bluetooth headset or Bluetooth speaker
connected with SK-BTI-029 before. No need to make the SK-BTI-029 enter into pairing mode.
2. If SK-BTI-029 did not connect with the Bluetooth headset or speaker more than 1 minutes.
Please try to clear up the pairing list of the SK-BTI-029. If the Bluetooth headset or Bluetooth
speaker connected with SK-BTI-029 before, please reopen the SK-BTI-029 after clear up the
pairing list.
Battery information
Your device is powered by a rechargeable battery .The full performance of a new battery is
achieved only after two of three complete charge and discharge cycles .The battery can be
charged and discharged hundreds of times, but it will eventually wear out. Do not leave a fully
charged battery connected to a charger since overcharging may shorten battery lifetime. If left
unused, a fully charged battery will lose power with time past. Leaving the device in hot or
cold places, such as in closed car in summer or winter conditions , will reduce the capacity
and lifetime of the battery .Should always try to keep the battery between 15
℃
and 25
℃
.
Battery performance is particularly limited in temperatures well below freezing .Do not dispose
of batteries in a fire as they may explode .Battery may also explode if damaged.
Safety instruction
Your device is excellent produce in design and craft, should be used with caution. The
following suggestions will help you effectively use warranty service.
1. Keep the unit away from children .
2. Maintain equipment dry, rain, moisture and all kinds of liquids or moisture can contain
minerals, corrode electronic circuit.
3. If the device is wet, please make it completely dry.
4. Do not use or put the devices in dust or dirt storage , it will damage the detachable parts
and electronic components.
5. Do not use equipment stored in overheating, high temperature will shorten the service life
of electronic devices, damage batteries, make some plastic parts deformation or melt.
6. Do not use equipment stored in a cold place, or when the device temperature to room
temperature, its internal will form the moisture, it will destroy circuit board.
7. Do not attempt to disassemble the equipment.
8. Do not throw, beat or vibration equipment, rough treatment equipment can damage the
internal circuit board and sophisticated structure.
9. Do not use strong chemicals, detergent or detergent to clean the device.
10. Do not use pigment daub equipment, daub will block sundries in the removable
components and thus affect the normal operation.
Note: Don’t stored SK-BTI-029 separate for more than one month without working, it should
maintain charging one time every moth if long time working. It can prevents built-in battery
uncontrolled excessive self-discharge phenomenon during storage.
