12
STEP 17 Unlock Connection
Unlock Cable color: Blue cable with Yellow and Red wires
.
(
See vehicle specific information before proceeding many modern setups require an unlock module
).
For this step see it is important to check your vehicle specific information sheet
before you proceed.
17A
Route the Unlock Motor Cable to the b-pillar or into the door being popped
17B
For Ground at rest systems; locate the unlock motor wire using a voltmeter; this wire
will go positive during unlocking and stay at ground when not active (at rest).
17C
Cut this wire attach the cable’s
Yellow
wire to the wire going to the Motor. Attach the
Red
wire to the wire coming from the switch/body control module.
Note:
There is a 10A fuse attached to the solenoid at the IntelaBox if the fuse is blown check
that the wires are in the correct direction and Check for shorts, kennel panel screws or other
shorts to the wire.
STEP 18 Solenoid Wires
Solenoid wire color: Orange
Solenoid ground wire color: Black
Be careful to route the wires away from the window’s travel and avoid sharp objects.
Connect Unlock to only the door that is popped.
18A
Connect solenoid ground to a good chassis ground point.
DO NOT GROUND SOLENOID TO DOOR the hinges make a poor ground.
18B
From the IntelaBox, Route 10GA
Orange
solenoid wire to the Door being popped open.
Pull the orange wire and ground wire into the door.
STEP 19 Attach Door Popper Wires
Attach unlock, neutral safety, and solenoid wires to the IntelaBox.
