ACE RC Cougar PS3i, Instruction Manual

Page: 13 / 24

Audio on Mode Audio off Mode
EPA position
Default 100%
Adjusting Range 0%~150%
12
1) Turn off the radio.
2) Press the “up”(+) and “right”( ) buttons and hold
them.
3) Turn on the radio, a short “Beep” is emitted (power
on) , followed by a long “Bi” tone (finish tone mode
switching). Release the “up”(+) and "right" ( ) button.
NOTE:
Repeat the above 1)~3) steps to switch back to “audio
on” mode.
3. D/R (Dual Rate)
Press the right edit button, then move the cursor to “D/R” and
the steering servo dual rate setting function. On the “Value
Display”, the current D/R value will be shown. Use the up and
down edit buttons to adjust the value.
Th2 D/R function adjusts the overall travel of the steering
servo. Under the D/R setting, the steering servo left and right
steering angles will be adjusted simultaneously.
More travel (Higher D/R %) means more sensitivity for the
steering wheel.
TIP:
You also can use the “Digital Steering D/R(Dual Rate) lever”
to adjust the D/R value all the time even the function selecting
cursor is not under the D/R mode.
4. EPA (End Point Adjustment)
The EPA (End Point Adjustment) function sets the maximum travel end points
for each servo. On both travels, the individual EPA can be set with different
values. Move the cursor to the channel you select to start the setting procedure.
4.1) EPA / ST
This function adjusts the right(R) and left(L) maximum
steering angle. Under this mode, the right steering angle
EPA setting is selected first. “R” and current EPA value
are displayed there. Use the up/down buttons to adjust
the right EPA. Turn the steering wheel to the left, the “R”
on the display switches to “L” allowing you to adjust Left
EPA.
Default 100%
Adjusting Range R 0%~120%, L 0%~120%