ACE RC Cougar PS3i, Instruction Manual, Page: 12 / 24

Menu
Value Display
Status Display
Trim position ruler
FUNCTIONS ( for PS3i )
11
There are 4 distinct areas on the screen: “Menu”, “Value
Display”, “Status Display”, and “Trim position ruler”.
Using the left and right “Edit Buttons”, the cursor will
jump to the function you would like to edit. When you
enter the menu function, you can press the up and
down “Edit Buttons” to edit the value. Upon completing
settings, simply press the right and left buttons to move
the cursor to other functions, the previous value is now
saved.
1. Power On
Slide up the “Power Switch” to turn on the radio. You will hear a short “Beep” tone. The “model number”( )
will be displayed on the “Menu” area, the battery voltage value”( ) will be displayed on “Value Display”
area, and “battery voltage status diagram”( ) / transmitter system ( “ ” ) and audio on/off setting
( “ ” ) RF Transmitting on/off ( ) will be shown on “Status Display” area.
The current neutral position of the steering and throttle servos are displayed on “Trim position rulers”.
If all the radio system and RF module are correct, and the switch is set on the “ON” position, then the RF
Transmitting sign ( ) will be shown on the “Status Display” to make you use the current model No setting to
play your model. Or use the “Edit Buttons” to start the programming procedure. The following are the set-up
procedure and detail description for each function.
NOTE:
1) Battery status is easily read on the voltage value or battery status diagram. Charge or change the battery
when the voltage is lower than 8.8V.
2) For the radio RF system, the Cougar P3i feaatures PPM system, so the PPM is shown on the display.
3) If you plan to study all the function setting
procedure, or to adjust many functions data, we
strongly suggest to cancel the RF transmitting
function before executing the setting procedure.
You can remove the RF module or put the power
switch on the “Display” position. Note that the RF
Transmitting sign ( ) will not be shown on the
display.
2. Audio on/off beep setting “ ”
Default “Audio On” mode
The audio default setting is “On” eventhough no icon is displayed on the screen. Under the “Audio on” mode, a
"Beep" is emitted whenever the edit button or digital trim lever is operated. The radio can be switched to
“silent” mode easily. When switched to “Silent” mode, the “ ” icon is displayed on the right lower "Status
Display" .
Tramsmitting on Tramsmitting off
2.4GHz Digital Radio System